All modern sound processes must pass their sound information through a very
specific graphic equalizer, which is, essentially, an ultra-sophisticated
tone control, adjusting and shaping the audible sound spectrum in [usually]
27 specific frequency areas, spread from each other at 1/3 octave intervals.
The setup of this equalizer, commonly called the "B-chain", is
critical to the perceived quality of the sound. It's adjusted using four
microphones, placed around the auditorium, to listen to "pink
noise" played through the sound system. This reference audio is then
graphically displayed on another device, a "Real Time Analyzer"
(RTA). It's all high tech and sounds quite foolproof...BUT...:
* There are variations in measuring devices. The so-called "RTAs",
which display the audible spectrum, come from several different
manufacturers, and can differ from each other...
* There are different microphones used by different companies. THX presently
recommends a "Countryman" microphone, which is the size of a small
computer chip. Dolby presently recommends using an AKG C460B microphone.
There are others also in use. Spectral variations among differing
microphones can be significant, and various technicians tell me that the
highly individualized equalization required of the Countryman microphones is
trouble prone...
* There is a concept, or theory, so to speak, as to where to place the four
microphones in the auditorium. However, not all cinemas are exactly the same
size and shape, and there is no absolutely specific placement chart: every
time the rooms are re-tuned, the microphones end up being placed in slightly
different locations. These different placements can obviously have some
influence on what's heard...which influences what's seen on the RTA...which
influences how the levels get set...
* There are differences in the test films: some are issued by the SMPTE,
some are made by Dolby. Some test films have been used by technicians for
(what appears to be) years, others are new from the lab. All of these have
various production dates, and possible laboratory variations...
And so, the tests and settings which on the surface appear to be totally
scientific are, in reality, a bit subjective.
Theoretically, on a Monday, I could have Disney studios in for a screening
of some sort. Disney projection engineers are usually accompanied by a Dolby
"Field Applications Engineer", and we would tune the house
"just right" for them, using the Dolby-preferred microphones and a
Klark Teknik RTA analyzer. And then, on Tuesday, I could have a technician
from our service support company (NCS, National Cinema Service) come in, on
contract for a studio like MGM -- and re-tune everything for MGM, using
different microphones and an Ivie RTA. And then on Wednesday morning, I
could have Universal Studios in for their screening, and we would re-tune
everything a THIRD time(!), this time using their Lucasfilm/THX
"R2" computerized RTA and the Countryman microphones.
Abacus Real Time Analyzer (RTA). Picture by Paul Rayton.
And at the end of all this, is the sound adjusted? Yes. Is it adjusted
correctly? ... That, I guess, depends on who you are asking and where the
microphones were placed! Luckily, this nightmare three-times-in-a-row
scenario has never occurred, but I've had several instances with two daily
re-tunings back to back. No matter how hard we try to isolate each and every
detail, there is still margin for interpretation and opinions.
Perhaps the best value of THX, at least as it relates to cinemas, is the
requirement that the auditorium maintain certain standards having to do with
external and air conditioning noise levels, and certain acoustical
characteristics having to do with the interior of the room itself and its
reverberation time. Accompanying illustrations show samples of some of the
measurements taken. Fig A is a typical stage speaker channel frequency
response chart, as averaged between the 4 listening microphones. Fig B is a
display of the background noise levels that the THX program looks for -- and
how our cinema #4 appeared on June 18, 1996. Fig C shows the reverberation
time for our cinema #4 that day. We were comfortably in the safe zones in
all areas, even with the air conditioning fans running. (Trace line
represents the maximums allowed). There are other tests also performed as
well.
Fig A: Hollywood Galaxy Cinema 4 THX center channel typical frequency
responce as averaged between 4 listening michrophones.
Fig B: Hollywood Galaxy Cinema 4 average background noise levels.
Fig C: Hollywood Galaxy Cinema 4 reverberation time.
It would seem, then, that we leave nothing to chance in our cinemas. Even
with the best of plans, however, things occasionally can go awry. For
instance, we occasionally shift prints between the various cinemas, as
dictated by seating requirements for the various special screenings. When we
do this, we try to add (or remove) the THX logo film from the beginning of
the feature.
However, once in a while, there are last minute changes, because a special
show has too many (or too few) people wishing to attend. It is not unknown
for us to have to switch prints between cinemas just 5 or 10 minutes before
showtime. (Thankfully, this happens rarely!) But in the course of this
shuffling, the placement of the THX logo gets "out of sync" with
the actual cinemas. So, one day, we had a situation as described, and had to
run a film in cinema #4 before getting a THX logo on the print. Well,
wouldn't you know...there is always a "know-it-all" around: this
day, we had some patron in the house who saw the show, knew "all"
about THX, left the theatre and proceeded to call THX/Lucasfilm in San
Francisco to complain that "the THX is turned off" at the Galaxy.
This scientific observation of his was based on not seeing the logo at the
start of the film. How do you explain to people like that (who know it all)
that you cannot "turn off" a wall and all the design
specifications?!?!
We also encounter the occasional folk who could be called the "THX
junkies". These are people who seem to not care about the sound of the
feature film, only that the THX logo is played as loud as it can be, short
of destroying every amp in speaker in the place! And, yes, they complain if
it is seems low. The reality is, of course, that in a multiple-screen
situation, we seldom have time to stand near a volume control for several
minutes, waiting for that precise moment to boost the sound for that one
logo, so it must play at the level that works for the feature film. (I have
seem some cinemas with PC-based automation systems; these are capable of
setting individual levels for selected bits of film.)
In the final analysis, is "THX" worth the extra cost? That's a
hard question to answer, seeing as how I'm not the one spending the extra
money to make sure the auditorium meets the THX standards. It does seem to
have a "plus" factor with the moviegoing public, and, as a
strictly unscientific comparison, listening to films in our various cinemas,
as the prints move around, it does seem that THX adds something, especially
with films such as "Twister" where sound design is important to
the emotional impact.
The word seems to be that cinema companies must pay something upwards of
$500 per year per screen to license the use of the name "THX".
Theoretically, they can't advertise their films as being "in THX"
if they haven't been certified as being in compliance "recently".
One US cinema corporation, Cinemark, has reportedly decided to stop paying
the fee, and therefore is not advertising THX, even though a good number of
their cinema screens were constructed to THX standards.
The matter of the re-certifications is also somewhat of a gray area: who
performs the "re-certs", and does a given cinema pass or not? If
the technician performing the "re-cert" is in the employ of the
cinema company, will he be honest as to the performance of everything, or,
if something "minor" is off, will he cheat on the readings a bit
to save his company money? And, I've heard reports that some
"select" cinemas have been failed by field engineers, only to be
told that, "Yes, that cinema passes"! This is a result of internal
politics between the owners and THX, apparently. So, some "THX"
may be better than others. Here in Hollywood, there are those of us who
question the certification of the original Chinese theatre, because the room
itself has a terrible problem with reverberation time (and sound is, truth
be told, hard to understand). But there it is in the ads: Presented in THX.
Really?
Interestingly, the three most important big screen film venues in Hollywood
are not THX certified, but they meet the most critical demands of equipment
and acoustical testing: The "Academy" Theatre (Samuel Goldwyn
Theatre, Ed) (of the Academy of motion Picture, Arts & Sciences [The
organisation that presents the "OSCARS"]); the theatre of the
Screen Directors Guild and the theatre of the Academy of Television Arts
& Sciences. These are built with the "THX wall" theory of
cinemacoustical design, but they select their own high-end audio components
(which may or may not be THX "approved") for the rest of the
system. These venues cannot tinker with reproduction quality for reasons of
saving a few pennies, as, sooner or later, every director, editor, sound
engineer, and every other job category that contributes to making the movies
will have occasion to be in there, and you can be sure they´ll complain if
things aren´t "perfect"! But none of these sites are officially
"THXd"!
Getting those improved standards of presentation into commercial cinemas
are, finally, the real reason for all the THX efforts. It would be nice if
they broadened their efforts to encourage higher standards in the appearance
of the image on the screen (i.e., push for 70mm film production and
releases) as well as sound system performance. A recent article in
"Boxoffice" magazine hinted that this would be happening.
That's why I personally find so troubling the dilution of the THX
"standards" into home video and videotapes. Many people now have
"THX approved" speakers with their home video systems, but I can
guarantee you, the experience is not the same as listening to that twister
roar across the large theatre screen. It may say "THX" on that
video speaker, but all the other components that enter into successful
theatrical, dramatic, motion picture presentation are completely out of
control. One has to wonder if they have been a bit too hasty in letting
everybody put "THX" on all that video equipment.
Even more distressing, I've seen "THX" on video tapes. If Joe
Customer plays that "THX" tape on his cheap home video system,
which may not even have THX-certified home equipment, what will THX do for
him? Virtually nothing. It will still look and sound about the same. And so,
what will his expectations be the next time he goes to a THX cinema or, more
importantly, thinks about going out to a movie, and debates whether to go
see it in a THX cinema, or a "regular" cinema?
Authors postscript: In part one it was stated that we must climb up to
change high frequency drivers "about once a month". That figure
was incorrect; we usually find it necessary to change a driver somewhere
among our 6 screens about every 3 or 4 month.
Life With THX In Hollywood Part 1
|
Further in 70mm reading:
Life With THX In Hollywood Part 1
Internet link:
|